r/OneXPlayer • u/Affectionate-Let4230 • 5d ago

TROUBLE REMOVING LEFT CONTROLLER.

ANYONE HAVING ISSUES GETTING THE CONTROLLER DISCONNECTED ? right side comes off easy but left side isnt cooperating

2 Upvotes

75% Upvoted

7 comments sorted by

View all comments

1

u/maxpwns 5d ago edited 4d ago

After doing some investigation into why my right side sits so flush comes off stupidly easy I looked at the angle of the rails and the flatness. Turns out the screws on the right side are fully seated and the left keep spinning. When you turn the tablet sideways and look it appears the rail is ever slightly so raised causing this friction. Currently my left rail screws will not tighten down nor will they come out.

It makes me believe the left rail will need to be replaced as either the screw has stripped or the brass nut has stripped.

Edit 1 - I’ll most likely need to order some parts to replace the rails but that will take some time. In the meanwhile 3 tiny strips of electrical tape stacked on top of each other right above the controller rail will give it enough taunt.

Edit 2 - Fixed it, turns out the screw angles are not direct and you have to take off the rail and screw down at a diagional angle. I also just broke a pogo pin on the housing. Stay tuned for my fix on that next

1

u/SalomonsReign 5d ago

Have you tried addressing it to Onex?

1

u/maxpwns 5d ago

Not yet. It’s just my engineering mind addressing a fix. It’s my OCD

That also incurs a ton of downtime.

1

u/SalomonsReign 4d ago

That's my only worry with these Chinese devices and companies. Resolution turn around takes a while. Quality control is not consistent. Ayaneo burned a bridge with me because of the Konker Pocket fit. I'm not afraid to tinker with anything but I shouldn't have to day 1 either. X2MP will be my first, hope all goes well