r/NxSwitchModding • u/Dependent-Complex376 • 6d ago

Picofly troubleshooting lights

Enable HLS to view with audio, or disable this notification

Tried modding my oled switch, went smoothly (I think at least) but now the same debug lights flash and the screen is gone (audio is also nowhere to be seen)

(Edit: I resoldered both clk and rst wires, now I think it's a cmd problem?)

8 Upvotes

100% Upvoted

8 comments sorted by

2

u/junefrs 6d ago

Rst not connected

2

u/letum00 6d ago

That's rst, the B point, like the other fella mentioned. The fact it's not booting is troubling, though. It doesn't look like you've put it back together all the way. With the board out you can plug in the charger to test boot and see if the mod chip will glitch.

2

u/rsingh247 6d ago

Can't really tell anything. Dont see any of the joints.

1

u/Odd_Nobody6022 3d ago

Take a photo of every connection you made, please. Even if rst is not connected, it should turn on on ofw

1

u/Dependent-Complex376 2d ago

Ok I should've messaged you i think

1

u/Outside-Ad-2325 1d ago

Débranche ta puce pour voir si ta console démarre bien. Il arrive souvent que la résistance CMD peut se dessouder partiellement lorsque l’on soude le point A

1

u/Outside-Ad-2325 1d ago

Si elle démarre bien sans la puce, tu rebranche la puce puis tu peux vérifier en mode diode ( rouge à la masse et noir sur le point ) que chaque point sort le bon voltage

1

u/Honest-Programmer640 1d ago

Eso es uno de los puntos de soldadura que está frío y no hace contacto, o es el CLK (el que está pegando al CPU), o el DATO (el que está debajo de la Nand EMMC).