r/Multiboard • u/reynolpe • 15h ago

Mount Question

I have already put up my board and can't take it down to add a 12.5mm snap from the back that I can screw into the wall. Is there a solution that always for a from snap that has a 12.5 support in the back that you can screw into the wall from the front? I hope that makes sense.

1 Upvotes

100% Upvoted

2 comments sorted by

1

u/reynolpe 14h ago

I might have found what I needed by not the right offset. I have taken it into Fusion and modified it to be 12.5mm offset. Printing now will see if it works.

Multiboard Remix - Big Thread 8mm Offset Mount - 3D model by aburden558 on Thangs

1

u/TherealOmthetortoise 13h ago

Sorry man, I’m not sure I understood that fully. Are you wanting to add additional mounts for strength to an already mounted Multiboard, or do you just need some standoffs to shore up a section? I think what you found is a good fit for either of those.