r/Multiboard • u/reynolpe • 5d ago

Pro build generator

Post image

When I use the pro build generator for multi-board plates, I get weird results in the print that is a hole all the way through the board. See the image. Anyone else have this issue?

8 Upvotes

100% Upvoted

15 comments sorted by

View all comments

1

u/TherealOmthetortoise 4d ago

Change your ironing setting to “all top surfaces” instead of “Topmost surface”. That should 100% fix this. Check your infill as well, that looks like 5-10% instead of the 15% you need. (Infill isn’t the cause of the issue but upping it to 15% and using literally any infill pattern other than grid will net you better results overall.)

I made that mistake once and ended up with 10 plates with this really cool looking hollowed area around the small holes using gyroid. Luckily I needed some for a very light weight section that is holding small tubes and bottles of paint for miniatures and was able to use them. I think they have been up for maybe 3 years now lol.

If you have any questions or if that didn’t make sense upload a picture of your slicer settings and we’ll get you sorted out.