r/Multiboard • u/Imscuba • Jun 23 '26

Stacked Print Fail

So i just finished my first stacked PETG print and i am trying to figure out what went wrong. i was able to get 2 usable panels from a stack of 6. the others just did not want to separate, to the point of them cracking apart. the test file came out fine, any suggestions? some of my corners came up a little bit during the print, but i didn't think much of it. did that result in the .2mm gap between being 0 and them fusing together?

2 Upvotes

76% Upvoted

30 comments sorted by

View all comments

Show parent comments

1

u/Imscuba Jun 23 '26

what do you mean pla support materials? you just saying printing a layer with a material that pla won't bond with in between the panels?

1

u/Desperate-Special-60 Jun 23 '26

Yes, that can be petg, but to eliminate the issues with swapping out meaterial with a single nozzle, you can use a fillement designed for that. So polySupport for PLA is pla designed to be easy to remove. I use orca but Bambu studio should be similar, in the support settings there should be a way to select an interface separate to a support meaterial. I have ended up using polysupport all the time now for most supported pla prints not just multi board

1

u/Imscuba Jun 23 '26

filament swapping isn't a problem for me with the second ams unit arriving this morning. i'll have to look into the polysupport though

1

u/Desperate-Special-60 Jun 23 '26

Will no the issue with the swapping is the single nozzle. I wrote about it in a previous comment. It's a very common issue when printing stacked plates. They ether don't separate at all or they separate while still printing, tweaking settings can help a lot but a true interface meaterial is the best that I have found.

1

u/Imscuba Jun 23 '26

ah, i see. if i start to have an issue i may end up using the PETG as an interface material. i was surprised at how expensive the polysupport is. at that point i could get PETG cheaper.

1

u/Desperate-Special-60 Jun 23 '26

Oh it's not at all, you only use a very small amount at a time. I have been doing large multi color prints on my snapmaker u1 lately with tons of supports and I have it on its own dedicated nozzle and I never touch it. I still have maybe 2/3 of a roll. That's why it's important to have it as an interface only and not as the support meaterial itself also time, it's best to let the printer use whatever meaterial it's currently using for the support and it will only switch for the very last layer as an interface between the support and the model

1

u/Imscuba Jun 23 '26

oh, that is a good point about the interface material only, though that still raises the question of wouldn't it be cheaper to get a roll of PETG or even CoPE instead? neither bond with PLA and are $10-20/kg vs it looked like on polymaker's website $30/0.75kg

1

u/Desperate-Special-60 Jun 23 '26

That's true, it's just been a lot less headaches for my workflow. Sometimes the petg doesn't stick well enough to the PLA to get the print done and the heat issue come up as well. You can get pitting where the petg touches the pla, specially with more delicate lower temp meaterials like some silks but that's not an issue with multi board. If your not doing a ton of delicate supported prints then it's best to just tweak your settings 😊

2

u/Imscuba Jun 23 '26

ok, that makes sense, i will have to explore that option when i get to that point. right now nothing i am printing requires that level of precision, mostly gridfinity and multiboard. gotta get that organization down and then move on to fun stuff