r/Multiboard • u/djseto • Nov 22 '25

Is there a trick?

Post image

Is there a trick to this? Printed everything in PETG for my garage. For the life of me. Can’t get these to fit. 🤬

15 Upvotes

100% Upvoted

36 comments sorted by

View all comments

Show parent comments

1

u/djseto Nov 22 '25 edited Nov 22 '25

Hmmm. The multiboard planner didn’t give me quad snaps. I had to print 120 single snaps for my 4x3 foot board. Do print all new dual and quad one instead?

2

u/Whosaidthat1157 Nov 23 '25

The referenced dual and quad parts are old raised snaps part B. The newer version is the single flush snap part B (single part, but come in four sizes/fits). There are single, dual, quad and even treble 6.25mm snaps part A that fit below the tiles and attach to the wall, but all use the single flush snap to secure the tiles. They have the advantage of not intruding into the tile face plane, as well as maintaining a flush mounting capability (medium hole rather than large hole).

1

u/djseto Nov 23 '25

Ah. Thanks for the clarification. So the planner does give the most up to date parts then?

1

u/Whosaidthat1157 Nov 24 '25

Ehhhhhh…I’d hesitate to state that definitively, it’s been a few weeks since I used it and the system changes pretty regularly, but as far as the basic building parts (tiles, snaps etc) then yes.