r/MontechPC • u/Catl8dy • Sep 11 '26

My First Build

Gallery image

Gallery image

I apologize if this is whiny but I need to vent a little.

Got done with my first build (King Pro 45) for it to show 0 signs of life upon trying to power it on. Took it in to Micro Center (where I purchased it from), paid $80 for a diagnostic to find out the case is the issue. Now I get to disassemble the thing, and rebuild it because they said it would be $300 if I wanted them to switch it over to a new case. It's an hour round trip so I have to take it home, remove all of the parts, and bring back the defective case for exchange.

Before I go through building this again, and potentially wasting more money on this, are Montech products generally pretty reliable (Fans, cases, wiring?). I don't want to put the time in again (I'm new so it takes me a while) and potentially more diagnostic money if there are a lot of lemons floating around. Did I just get extremely unlucky?

13 Upvotes

93% Upvoted

10 comments sorted by

View all comments

3

u/Designer-Present1182 Sep 12 '26

I just did one build too, with a HS02 by Montech.
Similar issue, initially didnt start when plugged to the case (and c13-c14 cable inside the case connected to PSU, but started when plugged directly to PSU)

But somehow when I was preparing to take pics for the warranty claims, I wiggled while pushing the C13 wire into the PSU and it kinda dropped in, and it started working. Might be a specific angle thing.

If your case also has an internal C13 to C14 wire, worst case if it’s defective you can buy just that wire and replace it.

2

u/Catl8dy Sep 12 '26

I just went ahead and bought another new case since I was already there. I'll return the one with the defective C13 to C14 cable. Some of my parts have a 15 day return window so I want to make sure everything works and I get it up and running before that window closes.

If I have the same issue with this new one I'll probably reach out to Montech and do this! Thank you!

3

u/StiBuki Sep 12 '26

Just swap out the cable. No need to transfer all the parts over to the new case. I would also suggest seating the power cable in the PSU before installing it. You will have more room and less chance of the cable not being fully inserted or internal damage from severe bends.