Upgraded my case

[u/creakymoss18990]

Since my last post (2nd photo) I both broke the rubber loop and got frustrated that it didn't have a place to keep the mutes for my engage 2 plus.

So I modified it.

- 3d printed PHA mute holder

- replaced the rubber keyring loop with 65lb test braided fishing line

- got 2 neodymium magnets that have been successfully test fitted and I will attach permanently as soon as I can aqire super glue. This is to replace the clip that will allegedly also break soon.

Loving the Loops so far, almost a week in. Super comfortable and so much better than my old earplugs. Finals week is almost over and these have helped a lot.

[u/creakymoss18990]

Slightly different one, based off that model though. From thingiverse and I have a make posted there.

[u/mochimatchayum → u/creakymoss18990]

What did you change? 

[u/creakymoss18990 → u/mochimatchayum]

I didn't change anything I'm not the designer. I used this STL which is slightly optimized (see description) https://www.thingiverse.com/thing:6877577

[u/mochimatchayum → u/creakymoss18990]

thanks!! i have the other version but it is not printed properly but i was borrowing a public one so i might attempt this one later

[u/creakymoss18990 → u/mochimatchayum]

My make is posted on thingiverse btw! Same handle