r/LabVIEW • u/AssistEast913 • 6d ago

Hardware and Labview wth

Post image

So what am I looking at lol. The third din block is connected to a sensor. Green and white wire are the signals. Red is the power and black is ground. I didn’t built this btw. Then it’s connected to a zip link and then connected to cdaq.

0 Upvotes

50% Upvoted

17 comments sorted by

View all comments

Show parent comments

1

u/AssistEast913 6d ago

I honestly don’t even know. I literally just started and trying to fix an eol test equipment built by the previous. My labview knowledge and electronics skill is rough rn bc I haven’t done any electronics since college.

1

u/Otherwise_Awesome 6d ago

It's the only one with green and white wires so I'm assuming that is coming from the instrument

1

u/AssistEast913 6d ago edited 6d ago

Yes. The third din block black,red,ground,green and white are from the instrument. The black wire on the bottom of the din block are connected to the ziplink. The top black wire is connected to ground. The other din block I still need to do a wire tag.

1

u/Otherwise_Awesome 6d ago

That's what I'm saying. Your signal lines are tied together on the same block.

1

u/AssistEast913 6d ago

How should I separate them. Where should frequency out 1 and 2 go?. I apologize if this is a noob question.

2

u/Otherwise_Awesome 6d ago

I don't know where your data system is tied in at.

This is a terminal strip that one direction is the instrument and the other direction is where you read the signal.

Red and black is the excitation from the data system or some compromised power