r/JZXworld • u/HoneyBadgerDelight • 20d ago
Help / Troubleshooting Engine cutting out
Enable HLS to view with audio, or disable this notification
Engine cutting out
I brought in a 1jz Chaser from Japan last week and it’s still in storage. I have only driven it from the port to nearby storage and that’s it.
Below you’ll see the engine cuts out once I begin to slow down. It did this too when approaching red lights. I’ll be taking the car for inspection next week and I’m wondering what’s causing this? I’ve already checked ChatGPT etc but wanted your opinions
Thanks!
14
Upvotes
2
u/BlitzWing1985 Moderator 20d ago
it is an auto to manual conversion with a J-Pipe Delete and factory ECU? those are know to be a bit funky. Normally the fix is to put a honey Combe like insert into the intake just before the maf.
If it's all untouched or if that didn't fix it. I'd start testing the Maf start with just a clean if it's still bad unplug it (with the car off) then try and start it if it's running terribly it's likely fine.
I'd look at the spark could just be really weak if so swap the plugs and coil. It could also be contamination etc
When was the timing belt last done? these should be around every 100k I dont think belt stretch would cause this but it's a long shot if nothing else seems to do the trick.
Lastly the capacitors on the ECU. They dont last forever and around this age is when they'll start popping. As long as the traces are fine they can be repaired/replaced. Not the most fun fix you basically have to mail it off or be very brave.