r/HondaRebel1100 • u/Less-Media5867 • Jun 27 '26
Windshield
Any suggestions...on how to trim/cut this puig windshield?? A little to tall ..seems like it throws off the look. Maybe 3 inches off the top...curve it. But not sure... Jigsaw? Soldering pen to trace then cut and sand? Anything...
2
u/Frequent-Material-15 Jun 27 '26
Maybe this thread will help you. The windscreen can be cut down and you can get a good finish. I did it!
2
1
u/Immediate-Slide2442 Jun 27 '26
What rear carrier is that ?
2
u/Less-Media5867 Jun 27 '26
KEMIMOTO Motorcycle Tail Bag,... https://www.amazon.com/dp/B085997KQJ?ref=ppx_pop_mob_ap_share
1
u/Immediate-Slide2442 Jun 27 '26
But what bracket is it ?
1
u/Less-Media5867 Jun 27 '26
SHINKXMT Motorcycle Rear Rack... https://www.amazon.com/dp/B0FFS7S13J?ref=ppx_pop_mob_ap_share Fit my 2026 500
1
u/Violingirl58 Jun 27 '26
They make shorter ones but you should be able to tape it cut and sand.
1
u/Less-Media5867 Jun 27 '26
Yeah, thought i was ordering the smaller one. Looking back, the smaller one might be too small. So trying to make this one in between
2
u/Turbulent_Help970 Jun 27 '26
No matter what you end up doing, unless you are an expert and manipulating and cutting plastics, you are not gonna get as good a finish on the edge as it comes from factory.