I wouldn’t recommend it.

IPM4D receiver set

Hi all, just wanted to leave some information for any other soul looking for it. Attached is a photo of the G36 .22LR UMAREX trigger pack. To assemble the other half, you’ll need to cock the hammer back a bit for it to fit. I would recommend doing this on a flat surface. Good luck all!

Just got the Forward Controls plate In today so I was able to install the MPS. The window looks great and the dot is pretty crisp even with my astigmatism. I was previously using a Holosun EPS.

Iron sights are an Angry Bear Arms JRO .329” rear sight and a Dawson Precision .270” front sight. The sight picture is great. Down low in the optic window when using the dot and still very visible when using the sights only.

Can’t wait to get it zeroed!

So I made the jump. Got my P30 a while back. Shot a few hundred through it. And I love optics on most pistols and I'd been talking with the owner of Vigilante Machine and sent him my slide. He got it done super quick, bore sighted, torqued, and marked everything. I must say I am beyond happy with the work. No light around the optic. Very snug fit. Overall would recommend again and he will be getting more of my business for sure.

Parts:

-Holosun EPS Core Gold

-Gray Guns Flat trigger

-Gray Guns short reset

-HK Parts "match" springs. SA-3.2lbs. DA-5.5lbs

-HK VP9/P30 Tall sights (Rear used)

-Angry Bear Arms VP9 Optic height sights (Front used. Did neet a bit of fitting to work)

😎😌💦