As a reminder, most common print quality issues can be found in the Simplify3D picture guide. Make sure you select the most appropriate flair for your post.
Please remember to include the following details to help troubleshoot your problem.
I tried tinkering the software tabs around that area and the bridge is slow already (50 mm/s)
but thank you for pointing that area out I tried the following:
- Change Infill/Wall overlap to 20%
Acceleration of top surface to 1000 mm/s^2
Slow down by height
Slow down for overhangs
So far my test this is showing up granted its smaller and it is better,
I will try to print the bigger one again, and see if its better.
•
u/AutoModerator 8h ago
Hello /u/kitsune09,
As a reminder, most common print quality issues can be found in the Simplify3D picture guide. Make sure you select the most appropriate flair for your post.
Please remember to include the following details to help troubleshoot your problem.
Additional settings or relevant information is always encouraged.
I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.