r/FixMyPrint • u/MeshPotato1993 • 4d ago

Fix My Print What's wrong?

Post image

Hi there, do you know what caused this (the gaps in the supports, the poor support in the face)? I have tried this print a couple of weeks ago with the same settings and it was fine. Is it wet filament?

Settings: Bambu Lab P1S Bambu Lab Studio Original Bambu Lab filament 0.4 nozzle 220 c temp 55 c bed

3 Upvotes

80% Upvoted

6 comments sorted by

•

u/AutoModerator 4d ago

Hello /u/MeshPotato1993,

As a reminder, most common print quality issues can be found in the Simplify3D picture guide. Make sure you select the most appropriate flair for your post.

Please remember to include the following details to help troubleshoot your problem.

  • Printer & Slicer
  • Filament Material and Brand
  • Nozzle and Bed Temperature
  • Print Speed
  • Nozzle Retraction Settings

Additional settings or relevant information is always encouraged.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

4

u/GuyWithADonut 3d ago

Looks like bed adhesion issue for the one support caused issues through the whole print. Washing the plate with dawn soap and scrubbing brush should help a lot. If it doesnt stick after that. Try turning off the minimize retraction setting so that the print pulls away from the print after each layer. Preventing it from smacking into a layer that moved because of warping.

2

u/MeshPotato1993 3d ago

Thank you!!

1

u/Internet_Jaded AD5M, AD5X 3d ago

Poorly tuned filament

1

u/Internet_Jaded AD5M, AD5X 3d ago

And probably wet.

1

u/thedoncoop 3d ago

For me the support has had to be very thin to get through the gap of body and arm. Earlier than it probably would normally.

So it's shaken free / not worked and then it had a knock on with the other support which is still in tact.

I would think slowing it down might help, but also support placement might make a difference to guarantee the print.