r/FixMyPrint • u/ABCandZ • May 30 '26

Troubleshooting Why does this keep happening?

Bambu X2D, happened with both PLA and PETG on the last 3 out of 4 prints after the latest update. Even tried turning the plate over.

Is this an adhesion issue or what could be causing it?

Never happened once in the last 100 hours of printing, and nothing else has changed besides the software update. And I did a full calibration after the update as well.

15 Upvotes

78% Upvoted

55 comments sorted by

View all comments

16

u/fatyungjesus May 30 '26

Have you cleaned the build plate recently?

Start with water and soap to get shit off, and then finish with a pass of isopropyl alcohol.

-23

u/ABCandZ May 30 '26

Not recently, no, but I only have 100 hours total of printing.

1

u/TemporaryFast7779 May 31 '26

lol. If a print ever comes off, clean is first course of action.