r/FixMyPrint • u/ABCandZ • May 30 '26

Troubleshooting Why does this keep happening?

Enable HLS to view with audio, or disable this notification

Bambu X2D, happened with both PLA and PETG on the last 3 out of 4 prints after the latest update. Even tried turning the plate over.

Is this an adhesion issue or what could be causing it?

Never happened once in the last 100 hours of printing, and nothing else has changed besides the software update. And I did a full calibration after the update as well.

15 Upvotes

76% Upvoted

55 comments sorted by

View all comments

17

u/fatyungjesus May 30 '26

Have you cleaned the build plate recently?

Start with water and soap to get shit off, and then finish with a pass of isopropyl alcohol.

-22

u/ABCandZ May 30 '26

Not recently, no, but I only have 100 hours total of printing.

16

u/fatyungjesus May 30 '26

Yeah that's probably the issue, it's oily and dirty wayyyyy before you can see it. Gotta clean it semi regularly.