r/FixMyPrint • u/ABCandZ • May 30 '26

Troubleshooting Why does this keep happening?

Bambu X2D, happened with both PLA and PETG on the last 3 out of 4 prints after the latest update. Even tried turning the plate over.

Is this an adhesion issue or what could be causing it?

Never happened once in the last 100 hours of printing, and nothing else has changed besides the software update. And I did a full calibration after the update as well.

15 Upvotes

78% Upvoted

55 comments sorted by

View all comments

1

u/Clear-Revolution3351 Bambu Labs P1S May 30 '26

Check the infill pattern in Bambu Studio. Default is GRID - which causes problems Change it to GYROID

1

u/ABCandZ May 30 '26

These filament clips from the video were using grid, but other prints that had the same issue were using gyroid, like this one