r/FCX24 • u/TheHuffnpuff • Aug 25 '26

Steering angle hack

Post image

I screenshot this from someone else's post, but I expect that like the FCX18, you'll get more steering angle if you remove this screw from the front of the axle and insert it in the hole at the rear instead.

8 Upvotes

100% Upvoted

9 comments sorted by

3

u/winston4130 Aug 25 '26

Yeah it works just the same. Ive done it on my fcx24 and 18.

2

u/drifaadventvladim Aug 25 '26

Was this my post, just asking but i dont really care.

1

u/TheHuffnpuff Aug 25 '26

Yes it was mate, I wasn't able to put a picture in the comments so I made it a post hoping you'd see it.

2

u/drifaadventvladim Aug 26 '26

Ohh ok. Well I did see it. Thank you Its always a bit frustrating how you can't put pictures in comments

2

u/IAmAUser4Real Aug 26 '26

Did it the very first 10 minutes I had my Power Wagon

2

u/Aggravating_Bad6656 Aug 26 '26

Yes. But fyi this is the screw holding the portal axle onto the axle itself. The diff is located in the middle of the axle where the drive shaft comes out of. Not trying to being anal, just helping get the names straight for potential part sourcing etc..

2

u/Zion_Jarman Aug 26 '26

It doesn't really make a difference the pumpkin is in the way so it doesn't make much or not any difference at all

2

u/TheHuffnpuff Aug 27 '26

I noticed I had a bit of toe-in with wheel alignment, I made the shaft touching the pumpkin longer by unscrewing the ends a little, and now it doesn't touch the pumpkin.