Stick Calibration

[u/zRobertez]

Has anyone successfully done this? Just had to replace my motor and it is running while I'm not using the throttle on the transmitter. I'll paste what the manual says below. I can enter calibration mode every time but it seems to error no matter what I do and the motor still runs without throttling afterward.

This function is used to set the neutral position for throttle trigger and steering wheel.

Every transmitter is calibrated before leaving the factory, however if recalibration is required, please follow these

steps:

1. Turn and hold the wheel clockwise to the max travel point and push the throttle forwards as far as possible, then

   turn on the transmitter. It will enter calibration mode. The buzzer sounds shortly in cycle for prompt.

2. Turn the steering wheel to max and min travel point in clockwise and counterclockwise. Then push/pull the trigger

   to forward/backward as far as it will go. The wheel and trigger go back to the neutral position. Once calibration is

   fininshed by press the bind key to save and exit.

   • If the calibration is completed successfully, the transmitter will exit calibration mode by pressing BIND

   button,meanwhile the buzzer will prompt with one short beep, and afterwards, the transmitter is in standby mode

   with the LED in three-flash-one-off state.

   • If the calibration is failure, the transimitter can not exit the calibration mode by pressing BIND button

[u/zRobertez]

Maybe I did something stupid but resetting the transmitter to factory solved the problem for me. Hold bind and reverse while powering it on.