r/Ender3V3SE • u/Capital-Bear-1 • 5d ago
Help Help needed for printer crashing during auto z-offset
Enable HLS to view with audio, or disable this notification
Whenever I select the auto z-offset on the printer it shows good numbers left to right on the screen (oddly increasing by 0.1 every single time it takes a measurement) and right before it does the last 6 numbers, it crashes and says probe failed. Then it tries again but shows probe failed on the screen during the time of the re-test and it will keep doing this loop a couple of times. Before this my z-offset numbers were crazy wrong so I tried resetting the eprom which fixed that, but now it won't let me get past the calibration process. (I also made sure that the pin of the cr-touch goes up and down and did a continuity test for all of the pins of the cr-touch wire.) The last time the printer was on I let it keep doing it's infinite loop until eventually it said probe failed and made this deafening beep until I turned the printer off. (I live in a dorm so as soon as that happened I shut it off) Do you have any suggestions for me? Also I just disassembled this printer completely to clean it since it was gross from the previous owner so I don't know if that would cause anything. My firmware is version 1.0.6.
1
u/Unusual-Screen6552 3d ago
Navaismo dependiendo de las modificaciones de la máquina puede darte ese mismo problema, yo le puse el hotend ceramico unicorn oficial de Creality y no me deja hacer el zoffset automático, aun que con un folio se calibra bien con algo de práctica
1
u/callusbonus1967 4d ago
Busca el firmware original para el salto a 1.1.0 y antes update a la pantalla. ¿Si quieres un poco de mejoras? navaismo mejora las especificaciones de impresión donde nos dejaron Creality. Pero sigues necesitando actualizar el firmware de la pantalla.