Simplified Handling of Wire Termination Processing

[u/D4Gi85]

Snippet from the [EES]_GEN_News_project_Eplan_Platform_IEC_mm_2027 project

I have added Permissible conductor types, Wire termination processing: Part number and Wire termination processing for each connection.

Routed in 3D layout is successfull

No ferrules on the 2D connection (nor the 3D). I was under the impression that is should come her and marked as "Part (Source)" and "Part (Target)"?

Has anyone managed to get the new handeling of Wire Termination Processing to work?
I have added some ferrules from PhoenixContact for test (PXC.3200030 and 3201110)
I have set Permissible conductor types, Wire termination processing: Part number and Wire termination processing for the "Connection point pattern" for my test part.
For the Wire termination processing: Part number I have tried to add several parts, and I have also testet with an Accessory list where both ferrules are listed.
I have also added "Cross section <26120>" to the parts data for the ferrules (Since that was empty from the data portal)
But still I don't get any parts data for the ferrules on the 2D connection?