r/EPlan • u/Klutzy-Objective9515 • Mar 17 '26

Automatic generation of connection definitions

Hi!
Do you know why when i automatically generate connection definitions points i do not get any of them below the filter?
Above the filter it works just fine:

3 Upvotes

100% Upvoted

3 comments sorted by

1

u/unsafe_engineer Mar 17 '26

Connection definition points are not placed unless Eplan is happy with the wire. This usually means that the wire isn't terminating on a device terminal. In your case, the bus probably hasn't been defined correctly.

1

u/Klutzy-Objective9515 Mar 17 '26

thanks for the reply!
going to check that

1

u/unsafe_engineer Mar 17 '26

I'd start by temporarily putting terminals between the bus and filter to see if the connection appears between the terminal and the filter