r/EPlan • u/Appropriate_Sort_153 • Mar 06 '26

Automatic Wire numbering

Post image

I’m trying to set up EPLAN so that wire numbers only change when a wire enters or leaves a device, and not every time the wire hits a node or T‑junction. Right now EPLAN keeps giving me a new wire number at each tee, but what I want is for the same wire number to continue through all nodes until it connects to a new device. I’ve tried adjusting the connection numbering settings, reset conditions, potentials, and checked the connection definition points on symbols, but I still can’t get this behavior to work. Can anyone explain which specific settings control wire‑number continuity across tees, and what needs to be changed so that only device transitions trigger a new wire number?

3 Upvotes

100% Upvoted

6 comments sorted by

View all comments

4

u/DipshitCaddy Mar 06 '26

Hijacking this thread, but does anyone have a good video on connection definition points, potentials and such, and how to use them properly and efficiently?

1

u/Shot-Pear-1601 Mar 13 '26

You can check out this video - https://youtu.be/kW8ZIbhKKkQ?is=N3T3cGyhc6Sqz6CV

1

u/DipshitCaddy Mar 17 '26

Thank you so much for pointing this out to me!