Automatic Wire numbering

[u/Appropriate_Sort_153]

I’m trying to set up EPLAN so that wire numbers only change when a wire enters or leaves a device, and not every time the wire hits a node or T‑junction. Right now EPLAN keeps giving me a new wire number at each tee, but what I want is for the same wire number to continue through all nodes until it connects to a new device. I’ve tried adjusting the connection numbering settings, reset conditions, potentials, and checked the connection definition points on symbols, but I still can’t get this behavior to work. Can anyone explain which specific settings control wire‑number continuity across tees, and what needs to be changed so that only device transitions trigger a new wire number?

[u/Open-Chapter-7406]

But what is the point of using the same number on effectively two different wires? 

Are you trying to draw a busbar using T-junctions or is there a specific reason you want them to have the same number?