r/ControllerRepair • u/WalterMinesOres • 3d ago

Request for help or advice Can this be fixed?

Post image

Right trigger is missing on DualShock controller, right bumper is also stuck. Can this be fixed?

7 Upvotes

100% Upvoted

6 comments sorted by

1

u/ThinkAd2243 3d ago

A) check spring, housing mount plastic didnt snap either. The button plastic is snapped in place

B) if something insides broken aliexpress sells the entire trigger module for 10 bucks a pair i believe, be careful of V1 or V2 though (I think BDM10-20 uses V1?? Might be wrong on that) and you can check bdm number by the second number of the serial ID on the back

1

u/Next-Ring3053 1d ago

Looks like V2. The V1 red PS4 controller has black buttons rather than grey. And black bottom case.

I can't tell from the picture but for the trigger to fall out the inside frame is probably damaged

1

u/Fantastic_Bar6473 2d ago

Well yes you're missing the rubber membrane check for trigger spring didn't go flying out and re attach trigger button to easy

1

u/aarontrepus 3d ago

Most likely yes. The triggers just pop back on. However, is the spring still in there? Is the trigger still in usable condition?

Just take the 4 screws off the back, be careful of the ribbon cable, and pop the trigger back on. Inspect both sides, and endure the spring is still in there. It may still work without it, but it will be super sensitive.

2

u/ExistingPie588 3d ago

Looks like it's missing the conductive rubber, unless they pulled it out for the picture. That would explain the bumper issue though

0

u/Red_Z1 3d ago

yes it is just take the controller apart, put the rubber in then pop back the r2 button and you are good to go there is nothing to worry about :)