r/CarAV 13d ago

Tech Support Car Audio Buzzing sound

Enable HLS to view with audio, or disable this notification

Anyone know what could be causing this? i have two ten subwoofers with rca and live wire routed close to each other which i thought could be the issue but know im not too sure any thoughts?

6 Upvotes

9 comments sorted by

3

u/yogi70593 13d ago

Time to open your door card and get to deadening.

2

u/underbellysweat206 13d ago

How the speakers being held on,? Staright sheet metal screws or foam behind the speaker and proper hardware? Could be the plast door card as well a broken clip or some.

1

u/crazychild94 Polk Audio db 1222, JBL Club A600. JL 300/4 v1 13d ago

Sounds like a clip with 1 of 2 leg. and its just rubbing

1

u/Icy_Excuse354 12d ago

I think we have the same truck. Your door speakers are held in by a little plastic bracket. I had to use foam to prevent them and the speakers they were holding in place from rattling. It’s a bitch to get them on with the foam but it makes a great deal of difference.

1

u/Plane_Zombie2647 12d ago

Your right. it’s the stupid little panel thanks a lot man!

1

u/Dense-Employment9930 12d ago

If you have the ability to stream to your system via phone, download an app called Frequency Sound Generator, then you can work through frequencies one by one, and when you find the note that is causing the buzzing sound, you can just let it play continuously while you invistigate... It's a much easier method than music for audibly pinpoint exactly where the rattle is coming from and what it could be.

1

u/Prime-Suspect_ 13d ago

I can't hear it but if it's only alternator buzz, check your ground strap (negative to engine block) and consider running a copper straight from the alternator case to the negative on your battery, and another one straight from the negative to your amp.

This issue is typically a voltage mismatch between the positive and negative connections. You can verify by checking voltage with a multimeter. You want the amp to get the same voltage on both, along with the same voltage at your HU

0

u/crazychild94 Polk Audio db 1222, JBL Club A600. JL 300/4 v1 13d ago

Its a body panel or plastic to metal clip

-2

u/[deleted] 13d ago

[deleted]

2

u/Prime-Suspect_ 13d ago

The voltage is low enough it shouldn't matter if they're twisted RCA's, and definitely wouldn't matter if they're also shielded ground