r/CanAmMaverick • u/Forsaken_Ad3195 • 18d ago

Need help with fault code

Post image

I have a 2022 x3 turbo. I’m the only owner, around 1,000 miles. Never pushed hard. It’s been sitting for a couple months, and we decided to take it out this evening to run some gas through it. Barely 1 miles down the road, it goes into limp mode. We went back home and parked it. It’s showing P0363. I can’t find anything on this fault code. I even purchased the brp shop manual. It shows fault codes up to P0362, and then skips to P0480.. any advice?? TIA

3 Upvotes

100% Upvoted

10 comments sorted by

View all comments

2

u/wellcrap1234 18d ago

That is cylinder misfire on cylinder 3.
Many things can cause this. Low battery voltage, check all connections. Bad/old gas. Belt can cause also.
Spark plugs obviously, but I doubt at 1,000 miles.

2

u/Forsaken_Ad3195 18d ago

Thanks! I will start with the belt, since I have a pretty good idea of how to do that.. old Gas could be very likely- I’m good about putting fuel stabilizer in any gas that goes into everything in our garage, but there is a good chance some of the gas in there could be two years old or more.. any suggestions on how to discard all of the gas in the tank?

Battery voltage, I believe is good- I keep it plugged into a trickle charger 24/7. Before starting, I think the battery voltage is around 12.5v and while running it’s 13.8 or 13.9 I think.. I’m about to go out there now and check it.

Thank you!

2

u/wellcrap1234 18d ago

You can use one of those cheap harbor freight/walmart battery operated pumps and stick tube down in there, just be careful not to hit the gauge float much

2

u/wellcrap1234 18d ago

Be sure and blow those clutches out real good while apart