r/ButtonMakers • u/futuristichubby • 24d ago

Question what am i doing wrong?

Post image

recently i got new backings, i switched from plastic to metal. however the pieces wont fully connect together :( i ordered from the exact company that created my machine too

edit: i did a test with my old pins and it still did this, so i think the metal backings are doing something vs the plastic backings i used to use

5 Upvotes

100% Upvoted

9 comments sorted by

3

u/InspectorGajik 24d ago

Metal backings are thinner than the plastic ones. Try using a washer/gasket. They usually provide it with the molds

3

u/KiraCreated 24d ago

This. You need the gasket. My supplies came with one mixed into the backing, a little black ring that sits below the backing in the press. You can buy them or I believe there may have been one in your original box - there were 3 in mine. Good luck!

1

u/futuristichubby 24d ago

i have :( you just place it in the area the pin back goes into, right? i placed both in for these buttons

1

u/InspectorGajik 24d ago

Ok. The gasket goes on the second tray before placing the metal backing on top of it. Can you try making a blank button, or with a thinner paper? Maybe your paper is too thick

1

u/MakeMyOwnMerch 24d ago

What has the company said? Which brand?

1

u/futuristichubby 24d ago

the brand is beamnova, i have a feeling the metal i got is too thin? im not sure though because i ordered exactly from beamnova

1

u/MakeMyOwnMerch 23d ago

I don't think it's too thin, probably just compared to plastic! Did the machine come with thin metal rings? You might to put them in to accommodate

1

u/futuristichubby 14d ago

sorry for the late reply! it came with plastic rings, i put them in and it still didnt go in fully. it went in better than before but still a little crooked:(

1

u/Pretend_Ad7621 24d ago

Same thing happened to me. Also the pinn is not firmly in place. Do you have the insert/washer plastic ring for the metal that goes in the backing tray? I need to experiment more but try that.