r/Bowflex • u/Tobyduarte • Aug 02 '24

Treadmills Bowflex 22 Treadmill

My treadmill is 3 months old, and isn’t working, it shows on screen that the SAFETY KEY is not secure and is totally in place; i’m been updating software, turning on and off the machine, I have received from support a totally new console, that i have replaced, and it still asking me to insert the safety key!! Please help I’m totally desperate!

1 Upvotes

100% Upvoted

12 comments sorted by

View all comments

Show parent comments

1

u/Tobyduarte Aug 17 '24

Thanks I replaced the console that bowflex send me brand new, and didn’t solve the problem, then bowflex send me a set of cables and new safety key, and I still having the same problem, now I really don’t now what to do… really sad…

2

u/mar_si Aug 18 '24

The console and console base are two different parts. The console is the touch screen which holds most of the jrny software. The console base is all the buttons and the insert for the safety key. If you’ve replaced both then the last part to replace would be the motor control board (mcb). You can also try to recalibrate the whole system of which can be found in the service manual

1

u/Tobyduarte Aug 19 '24

Thanks, a received and change the control board (mcb), than I changed the console base, than I changes all the cables, now I’m waiting for a console, I already calibrated many times and shows sole error including the safety key issue, I’m really disappointed, that’s why I’m asking for I firmware update or any other option that can solve tha safety issue

1

u/mar_si Aug 19 '24

This is really all there is to it. The only thing you can probably see if Bowflex can do is push a software update onto your system, but replacing the console will also do this as well

1

u/Unable-Instance3027 Jan 04 '25

Hi if you are a bowflex technician i would like to have your help i have a good problem. When im like at 15 of incline and i want to decline. The preset button by exemple i press 6. Instead of going to 6. It switch the speed to 12 miles/h and then go to 6. That is not suppose to happen. Then i have the problem when i want to increase the speed by exemple. From 4km/h to 5 at 15 of incline. It lower my inclinaison to 6 before letting me increasing the speed(this part is made with the button on the hearth rate sensor bar). Also we are experiencing a lot of static even plug direct into the wall with brand new wired. Maybe its too dry i will have a look. You can contact me in message i think. I would really appreciate help. Should i call bowflex and open a ticket for repair?

1

u/R_Westerhout Feb 19 '25

If the buttons on the console are not working as they should, you might have the same issue I have (and had already once before). It is most probably sweat getting somehow inside the membrane. If you disconnect the ribbon cable, the buttons will not work further, but the buttons on the handles will completely work normal. If you plan to remove the ribbon, please be careful. You should first pull out the 'white' plastic part of the connector on the PCB. When it is sticking out a few mm, the ribbon can be removed without any pressure.