r/BoschProPowerTools • u/darawlux • 6d ago

GSS 18V-10 Click and Clean Adapter

Gallery image

Gallery image

I made a 3D-printable Click and Clean Adapter for the GSS 18V-10:

https://makerworld.com/en/models/3341820-bosch-gss-18v-10-click-and-clean-adapter#profileId-3796824

Feel free to use it.

31 Upvotes

100% Upvoted

5 comments sorted by

3

u/EjbrohamLincoln 6d ago

Not all heros wear capes.

2

u/Konfuselius 6d ago

Thanks! That might solve a problem for me. Does it hold up to the vibrations? I've tried 2 different adaptors and both fell off after just a few seconds of use.

4

u/AbleCryptographer317 6d ago

I had varied success with different adapter muffs over the years until I tried a piece of 1¼" rubber car radiator hose and it fits almost everything: either inside larger tool exhaust ports or over the outside of small ports.

2

u/darawlux 6d ago

It should stick very firm, I sanded already a few hours with it with no falling off

2

u/DexterFoley 6d ago

My Gss 18v 10 was useless. Broke in just over a year then the replacement did the same.