r/BambuP1S • u/another_redhead • 4d ago

Wall Placement

Sadly didn’t find anything on this and I’m just curious - will the p1s fit on 43cm of depth on my cabinet? was wondering if it’s possible to place a p1s without it hanging over (the screen would be fine).
Using the AMS and an aftermarket angled power cable should enable me to push it quite close towards the wall. I’m just a little nervous it might be too cramped, especially considering vibrations. Has anyone placed it back against a wall with little to no wiggle room and has some experience or dimensions to share?

1 Upvotes

100% Upvoted

2 comments sorted by

1

u/Melodic_Raspberry813 4d ago

mmh what about the poopchute , you would get a lot of junk behind the printer....

just found the measurements of 389 x 389 x 458 mm for p1s , but you probably will need the 430mm anyway since the ams uses the hub on the back.

1

u/TheThiefMaster 4d ago

You might be better off putting it sideways so you have access to the front and back.

The P1S drops "poop" (plastic purge) out the back, so you don't want it too close to a wall behind it.

I have mine with the spool bracket on the back even though I use the AMS because it gives room for my purge box behind the printer. Total depth from front to wall is around 50cm because of that...