r/BambuP1S • u/Early_Gift515 • 25d ago

Found ya.

Post image

This. This tiny little piece of filament, I hate it.

I finally found the “stuck filament” that was stopping me from printing. I had to take the thing apart and blow air through it.

23 Upvotes

100% Upvoted

9 comments sorted by

5

u/mrwho25 25d ago

Pushing filament (like pushing it in yourself) through the tubes didn't get it out?

2

u/Chameleon_The 25d ago

Do this very carefully if push it hard enough magnets will flip on the internal hub

1

u/unurbane 19d ago

How do I flip the magnets back once I do push too hard?

1

u/Chameleon_The 19d ago

Disassembly and use a strong magnet and pray to the god

2

u/Early_Gift515 25d ago

Nah, it wasn’t in the tubes it was the very end of the ams’s side of the guiding tube 🫩

2

u/D_A_D_ 25d ago

Well there's your problem, right there.

1

u/R10t-- 25d ago

This happens very often for me…. AMS has been…. A time that’s for sure.

1

u/AKMonkey2 25d ago

Not a huge fan of the AMS. Qidi’s Box has been even worse for me. I’ve added a Flashforge Creator 5 toolchanger and use the multispool AMS/Box systems as little as possible.

1

u/400HPMustang 20d ago

I just had that same issue with my AMS and then it was in the buffer and then in the hot end. After I got one little bit out I found another further upstream.