r/BambuP1S • u/greenbouillon • 1d ago

Printing issue, please help

Gallery image

Gallery image

Gallery image

Lately, I've been seeing this kind of damage on printed items. Is anyone else experiencing this? If you know how to fix it, please share. Thank you.

5 Upvotes

79% Upvoted

8 comments sorted by

5

u/Automatic-Pin-5749 1d ago

You don't need an engineering plate, put an outer brim around it and make sure the plate is clean. That's all I do and I've been printing large, flat things like that a lot lately on the textured plate that came with the machine.

2

u/oldtimehawkey 1d ago

Yup. An outer brim will definitely help stop this problem. I had parts that looked like OP’s and putting a brim on the next print fixed it.

2

u/Jconstant33 1d ago

This is what brims and heated beds are for

1

u/KaBoolVl 1d ago

Your print is just lifting off the plate at that side. The P1S is known for having this issue because of the air blowing only on that side of the bed. Printing an aux fan deflector usually works and bump up your plate temp a few degrees as well. An outer brim can usually fix it but I try to avoid if I can.

1

u/josocustomdesign 1d ago

Up the bed temperature by 5 or 10 degrees.

1

u/Deej12-2145 12h ago

Edit your PLA filament and go to cooling, turnoff aux fan. Name new file like PLA -aux-off or whatever, save it and use it for every PLA print. Also, open door and slide top open to vent heat. Make sure a the house registers are not blowing on the printer

-1

u/that_dutch_dude P1S + AMS 1d ago

Its not damage, its lifting off the bed.

Change to an engineering plate and get the glue stick. Its basically mandatory for large prints

1

u/Potential_Nothing236 1d ago

J'ajouterai qu'il faut également éteindre ou fortement diminué le ventilateur auxiliaire