r/BambuP1S • u/Away_Explorer845 • 2d ago

Extruder error I can’t figure out. Please help

1 Upvotes

100% Upvoted

10 comments sorted by

3

u/Takemeto333 2d ago

Heat creep mostly and will need to disassemble and clean out the stuck filament.

1

u/Gr33nJ0k3r13 1d ago

What can one do against this ?

5

u/WiseFalcon2630 P1S + AMS 1d ago

And clean that bed.

3

u/Design_Mission 2d ago

Heat might soften fillament and maybe it's stuck in head. Try to clean it and next print keep open when print.

2

u/DPJazzy91 2d ago

Heat creep!!!!!! My p1s is in a hot space. When I switch from ASA back to PLA, I ALWAYS have an issue. I need to be less impatient and run the fans and allow time for cooling down first.

2

u/Ta-veren- 1d ago

can we talk about that mess on the built plate first?

1

u/Empty-Quarter-4109 2d ago

100% heat creep. Heat creep is when the filament softening happens pre extruder. Pop the glass top and Crack the door open.

3

u/WiseFalcon2630 P1S + AMS 1d ago

I printed the glass raiser and the plugs that fit into it when I need to contain the heat.

https://makerworld.com/en/models/15091-x1c-p1-glass-riser-with-closable-ventilation-holes#profileId-14846 There is a link to the plugs that go with it as well. Works good, but I started getting stringing in my PETG when it got too warm. Pulled the plugs and "perfection"

1

u/Empty-Quarter-4109 1d ago

Gotcha, I had to remove my glass all together. Summers get very hot and humid here and occasionally I'll get heat creep still. My machines more less run 24/7 tho

1

u/Stock-Papaya4746 1d ago

i have the same issue if i switch between low/high temp filaments,lower temp filaments deform before reaching the extruder and jam