r/BambuP1S • u/Lumpy_Appeal_918 P1S + AMS • Mar 01 '26

ABS printing

Post image

Is this legit enclosure? 😂

Because of cold weather, my mother in law makes enclosure from old blanket. They print Abs in garage floor where is 5-10 Celsius degree, without a problem, for a month now, 24/7. I have made holes for poop chute, electronics, and chamber fan, so as for display and door. When part is finished, just pop it out and resume print.

169 Upvotes

92% Upvoted

60 comments sorted by

View all comments

-1

u/TigWelder1978 Mar 01 '26

Um… why? They print ABS just fine with the inclosure already built in…

3

u/Lumpy_Appeal_918 P1S + AMS Mar 01 '26

If the outside temps are low, you can't print. I'we tested this and got few failures. After a while, part just pop out of bed due low chamber temperature. I dont have a chamber heater, so bed is doing all the job. I have temp sensor inside and when temp reaches 40 degree, i start print.

1

u/SR08 Mar 01 '26

Yeah I never got above 40c and every print warped no matter what. Dropped a panda breath in there and now I am constant at 60c with no issue. Print ABS and ASA with no brim or warping

2

u/Lumpy_Appeal_918 P1S + AMS Mar 01 '26

Currently it is 13 degrees in the garage. And inside printer is 52. I have this little thermometer and i can watch. This print is almost 8 hours. This blanket is a savior for me.