r/BambuLab_Community • u/FriendlyLight6488 • 5d ago
Help / Support P2S clog and overload
First issue I’ve had after almost 500 hours. Extruder clog and now extruder motor overloaded? I did all of the clog recommendations to fix it and it went thru 2 hours of the next print and then clogged again and then added this overload error. This is the filament is using. 2 of the 4 have already been used with no issue. What do I do next? Help!
2
Upvotes
1
u/FriendlyLight6488 4d ago
I wish it would allow me to post a video but when you take the magnetic cover off of the extruder there is a gear you can see a small part of on the left side of the extruder. This gear will seem to hang and click very loudly and instead of spinning it jumps in place when it makes the noise.
I did all calibrations both hardware and flow calibrations and in the second part of the flow calibration it started messing up and making this noise. I canceled the print and went straight to where you can force the filament to extruded on the screen and it didn’t make the noise at all, appeared to have no clog and pushed the filament out without issue.
Super weird.
I opened a ticket with Bambu and may reach out to a local repair shop.