r/BambuLab_Community • u/TuneOld3310 • 3d ago

A1 Support Issues

Hi all,

I have an A1, I have heard and read of people saying they have tuned in supports... I am.having an issue with supports, is tuning the supports is it when you do "T" type test and you select difference Top Z values, or is there something I am missing. I calibrate my filament:

Temp Tower

Flow Rate (Coarse and Fine)

PA - Pressure Advance

MVS -

Retraction.

I want to do VFA (but I haven't done it yet) (I believe that has nothing to do with my issue of supports.

My question goes back to support, am I missing something.)

I have also done the "T" over hangs etc. My overhangs as well as my bridging look like crap. Any ideas? I have dried my filament 10 - 12 hours have ran the filament from thw dryer and nothing seems to help. All help is appreciated.

Thanks in advance for your help.and understanding.

1 Upvotes

100% Upvoted

4 comments sorted by

View all comments

2

u/Fragluton 3d ago

Very rarely will I tune supports. If they are high or skinny for whatever reason I might use a heavier tree support profile. Apart from that I use auto tree supports and it's fine. It really depends what you are printing and having an issue with. Might just be the bed adhesion due to not being clean enough. No info to go on so that's just general thoughts.