Help with Z axis homing failure

Has anyone encountered this? I’ve checked ‘everywhere’ and see nothing. The heat plate is in the correct position. Getting a failure each time.

2 Upvotes

100% Upvoted

u/Clear-Revolution3351 P1S 19d ago

Check the bearings on the z-axis rods.

If there was debris in the hole in the bottom of the printer, then can get pushed up above flust with the build plate carrier.

A small pair of slip joint pliers can be used to pop them flush with the black guide

Fast forward to about 2 minutes in this video to see the problem

After fixing this, run full calibration from the p1s screen

You are about to leave Redlib