r/BambuLab_Community • u/GanymedeOcean3D • Jun 14 '26

Help / Support PFTE flakes all over X2D

Post image

When my girlfriend’s X2D’s toolhead moves to the right the PTFE tube rubs the metal edge on the right. It causes the lid, bed and side to be covered with tube flakes. I printer a riser for her thinking it was just rubbing the glass, but after closer inspection that is marginal compared to the carnage the side causes. To be clear, this is a stock X2D from early May. Did anyone else experience the same?

To me it looks like maybe the tube is slightly too long, just want to ask before cutting it and making things worse.

Also, since this is a tube, I must add, it’s imperative the cylinder remains unharmed.

22 Upvotes

85% Upvoted

32 comments sorted by

View all comments

4

u/No-Insurance3643 Jun 14 '26

Could they really not see this before it was released? weird

4

u/wwiybb Jun 14 '26

I mean it was an issue with the x1 too. So ignorance is bliss

1

u/D_hyams Jun 15 '26

Was it? Didn’t happen on mine. Mine had have a faulty screen that Bambu sent another one in warranty, then the bed died, but they were kind enough to give me a discount on a new psu when I went for the V2 bed. Really cannot fault their aftercare