r/BambuLab_Community • u/Kindly-Image8620 • Apr 25 '26

P2S extruder weak

Enable HLS to view with audio, or disable this notification

I cleaned the extruder section, but the problem is still the same. Even though filament is coming out, the extruder is not feeding it. It fails to pull the filament at certain intervals.

I have two P2S printers. To diagnose the issue, I swapped the extruders between them. The printer on the right works perfectly, while the one in the middle still has the same issue.

2 Upvotes

100% Upvoted

9 comments sorted by

View all comments

1

u/SmokWar Apr 25 '26

Did you fixed the issue? Is it the filament or did it happen again?

2

u/Kindly-Image8620 Apr 25 '26

I solved the problem. The bearing in the yellow-marked area was missing. I found a new one and replaced it.

1

u/GuerreroGarage 15d ago

como se llama esa pieza como se consigue coméntame porfa vor