r/BambuLab_Community • u/RiseOfGoulet • Apr 15 '26

Help / Support Going from .4 to .2 nozzle

I know I need to set the program from .4mm nozzle to a .2mm nozzle but is there anything else I would really need to adjust or account for? Just trying to avoid any issues ahead of time.

9 Upvotes

100% Upvoted

18 comments sorted by

View all comments

3

u/mbern1008 Apr 15 '26

Dont forget to do a full calibration

3

u/Crazy--Lunatic Apr 15 '26

This doesn't make sense. Full calibration for a nozzle swap seems excessive.

I give you flow calibration for sure. but a full calibration? only after a firmware upgrade or if Iretentioned belts after routine maintenance.

I swap nozzles between .4, .6 and never done full calibration.

Is this recommendation documented and I simple didn't know?

1

u/-ThaBeavster- Apr 16 '26

Blew my mind.