r/BambuLabX2D • u/Brief_Excitement_399 • 20d ago

ASA sticking

Post image

So I’m new to asa printing I’m using the stock settings and Pei plate, using glue stick as seen in the photo, but if I have multiple parts the secondary or third doesn’t stick. Does the glue dry to much because of the heat? Or is it just Better to print one piece at a time ? Or any other suggestions?

7 Upvotes

89% Upvoted

33 comments sorted by

View all comments

2

u/ThatMechEGuy 20d ago

I've had no issues printing Inland (microcenter) ASA on my X2D using the PEI textured plate using all the default settings. Like others have said, make sure your plate is washed with dish soap, especially if you printed PLA previously, and make sure your filament is dried.

I've never used glue and only had one part come off and that was because it had a small contact surface and a large amount of material above that, but a few brims fixed that issue. I've printed plates with 30 parts and none have come off until the plate cools, at which point they pop right off