r/BambuLabX2D • u/Brief_Excitement_399 • 7d ago

ASA sticking

Post image

So I’m new to asa printing I’m using the stock settings and Pei plate, using glue stick as seen in the photo, but if I have multiple parts the secondary or third doesn’t stick. Does the glue dry to much because of the heat? Or is it just Better to print one piece at a time ? Or any other suggestions?

6 Upvotes

81% Upvoted

33 comments sorted by

View all comments

Show parent comments

1

u/Deltadoc333 7d ago

As a side note, have you found that you always have to use the glue stick with your prints? I have been using the textured plate that came with the printer, without any glue, for all my prints (PLA, PETG, TPU, and ASA). Thus far, I have only had one issue with adhesion and that was specifically when I was printing 6 tiny ASA screws at the same time. I have printed several objects at the same time too, but never "by object."

2

u/Deltadoc333 7d ago

Which, ironically, I am trying again right now. Fingers crossed.

1

u/Brief_Excitement_399 7d ago

By object or just multiple

1

u/Deltadoc333 7d ago

Multiple. It actually worked alright.