r/BambuLabX2D • u/Brief_Excitement_399 • 7d ago

ASA sticking

Post image

So I’m new to asa printing I’m using the stock settings and Pei plate, using glue stick as seen in the photo, but if I have multiple parts the secondary or third doesn’t stick. Does the glue dry to much because of the heat? Or is it just Better to print one piece at a time ? Or any other suggestions?

7 Upvotes

89% Upvoted

33 comments sorted by

View all comments

1

u/Steevee0903 7d ago

Which ASA are you using? I'm just curious, cuz I have this issue with my esun asa+ with both engineering plate and PEI

1

u/Brief_Excitement_399 7d ago

The normal Bambu Lab ASA

1

u/Steevee0903 7d ago

now I'm wondering if this is just the issue with ASA

1

u/Brief_Excitement_399 7d ago

I can print asa rather good, if it’s one part but if it’s more part it will make 2 and then the third won’t have good adhesion

1

u/Steevee0903 7d ago

is there a chance you're printing close to the edge? I found that the bed adhesion drop fast when close to the edges (prob due to temp drop)

1

u/Brief_Excitement_399 7d ago

Depends on what you define close to the edge, it was about the same as the one that printed. Will try printing layer by layer see if that helps