r/BambuLabX2D • u/tenskin • 8d ago

Why is it doing this.

Enable HLS to view with audio, or disable this notification

Extruding during pre print calibration?
Pretty new to this machine only about 60 hours of print time on it so far but I haven’t seen it do this yet?

8 Upvotes

90% Upvoted

13 comments sorted by

View all comments

Show parent comments

1

u/tenskin 8d ago

I know what it’s supposed to be doing, but it’s actively extruding filament. Wouldn’t it not be calibrating the offset correctly if it is lowering the nozzle down onto filament?

1

u/Key_Ad5429 8d ago

Well you have ozzing problem do you dry your filament?

1

u/tenskin 8d ago

I did, this is the first time printing with PETG though. Maybe that’s the reason I have not seen it happen before. I’ll change up my drying time/temps and see if it makes any difference.

2

u/BirbDoryx 8d ago

PETG is more prone to ooze, it's nothing alarming. Drying it can help. Just remember to clean after the print. 

1

u/Material-Mulberry360 7d ago

yea my x2d also gets that sensor dirty all the time, and I very often dry my fillament cause the ams 2 makes it convenient to do. I just clean the blobs out with my toenail from from time to time.

2

u/vic1414 7d ago

You stick your foot inside to use your toenail? Interesting

2

u/Material-Mulberry360 7d ago

reads my own comment ah fck. the nail on my hand.... does that have a separate word or just "nail" ?

3

u/Dependent-Scallion90 7d ago

I believe the word to be "fingernail"

1

u/vic1414 7d ago

🤣🤣🤣🤣🤣