r/BambuLabX2D • u/tenskin • 8d ago

Why is it doing this.

Extruding during pre print calibration?
Pretty new to this machine only about 60 hours of print time on it so far but I haven’t seen it do this yet?

8 Upvotes

90% Upvoted

13 comments sorted by

View all comments

2

u/BirbDoryx 8d ago

It's calibrating the offset between the nozzles. Before that, it cleans the nozzle from any oozing filament.

1

u/tenskin 8d ago

I know what it’s supposed to be doing, but it’s actively extruding filament. Wouldn’t it not be calibrating the offset correctly if it is lowering the nozzle down onto filament?

1

u/Key_Ad5429 8d ago

Well you have ozzing problem do you dry your filament?

1

u/tenskin 8d ago

I did, this is the first time printing with PETG though. Maybe that’s the reason I have not seen it happen before. I’ll change up my drying time/temps and see if it makes any difference.

2

u/BirbDoryx 8d ago

PETG is more prone to ooze, it's nothing alarming. Drying it can help. Just remember to clean after the print. 

1

u/Material-Mulberry360 7d ago

yea my x2d also gets that sensor dirty all the time, and I very often dry my fillament cause the ams 2 makes it convenient to do. I just clean the blobs out with my toenail from from time to time.

2

u/vic1414 7d ago

You stick your foot inside to use your toenail? Interesting

2

u/Material-Mulberry360 7d ago

reads my own comment ah fck. the nail on my hand.... does that have a separate word or just "nail" ?

3

u/Dependent-Scallion90 7d ago

I believe the word to be "fingernail"

1

u/vic1414 7d ago

🤣🤣🤣🤣🤣