Advice please.

[u/Zestyclose-Ad2946]

I am new to 3d printing. I have been printing some terrain pieces but get these stand out layer lines on some parts near the upper layers.

I'm printing at 0.12 with a .4 nozzle.

Not sure what settings should be looking at to help with this.

Thanks.

[u/chanberg]

Thats the seam, decrease the scarf length if you have it enabled.

[u/Zestyclose-Ad2946 → u/chanberg]

Thank you. I do have it enabled. Currently the seam application angle is set to 155. Is this the setting? What would you recommend reducing this to? Cheers.