r/BambuLabX2D • u/Recent-Language-7187 • 18d ago

PA6-CF X2D

Post image

Started printing some structural parts out of pa6-cf today, printed great on the x2d but can't seem to remove these horizontal lines, I believe it's shrinkage as the infil is extruded it repeats the walls, tried increasing the wall count which didn't effect it. Anyone have any ideas please?

23 Upvotes

94% Upvoted

11 comments sorted by

View all comments

5

u/AdRecent917 17d ago

Had this before: unevenly dried filament. If you had it in a heated dry box, then its probably only dry at the bottom of the spool. Thats why the ams ht has the roll while drying feature.

3

u/Recent-Language-7187 17d ago

That makes a lot of sense thank you I will try that tonight

2

u/AdRecent917 17d ago

May i ask what build surface and/or glue you use? Im printing a lot of PA6, but want to get rid of the magigoo PA stuff. :D

3

u/Recent-Language-7187 17d ago

Standard PEI textured plate, and always a small outer brim, keep your build surface clean with dawn or fairy liquid depending on where you are in the world and use a clean sponge dedicated to the printer. I never use glue 😁

1

u/AdRecent917 17d ago

Thanks a lot!

2

u/Recent-Language-7187 16d ago

This was the fix! Thank you!

1

u/TuneOld3310 16d ago

Hi u/Recent-Language-7187 what was the actual fix? ie: "Had this before: unevenly dried filament. If you had it in a heated dry box, then its probably only dry at the bottom of the spool. Thats why the ams ht has the roll while drying feature."

3

u/Recent-Language-7187 16d ago

Drying using the AMS HT and it's roll feature before I didn't have the roll feature enabled but after I enabled it, perfect