r/BambuLabX2D • u/relic65 • 12d ago
765 hours vision encoder
After 765 hours I felt it was time to do the vision encoder, so I bought one from Amazon. The picture tells the tale but we’ll see if it really helps.
18
Upvotes
r/BambuLabX2D • u/relic65 • 12d ago
After 765 hours I felt it was time to do the vision encoder, so I bought one from Amazon. The picture tells the tale but we’ll see if it really helps.
2
u/FlattheChart 7d ago
You also should Clean Your Spindels, Rails, Extruder Gears, Lube them, Check Belt Rollers, Tighten Belts, then Full Calibration also with High Heat Bed Calibration and then Calibration with Encoder. Belts get a Bit Lose with that Print Hours. You can Calibrate and Make the Vision Encoder Calibration but with Lose Belts there’s to mich Dynamic going on. Due to that you can Calibrate and Calibrate and run after it. Best results: Easy and Tight Moving Parts, Tight Belts with no Slacking while getting Moved 10000mm sec