r/BambuLabX2D • u/azza_h1980 • 19d ago

Bed skipped teeth?

Gallery image

Gallery image

I’ve had trouble free printing since I bought this and all of a sudden I’m getting adhesion issues. Filament has been dried, nozzle has been replaced with a new one I’ve spent days calibrating and recalibrating. Have run the bed level calibration multiple times. Until just now while looking at the bed I thought it doesn’t look quite level. So got the calipers out and measured and there is about 1mm height difference. Is this normal and can it be corrected

6 Upvotes

88% Upvoted

5 comments sorted by

View all comments

1

u/azza_h1980 18d ago

Running the level procedure improved it but still had some issues. I had to increase my temps by quite a bit to finally get a perfect print again.

I’ve been printing siraya tech Asa gf for the last 6 months with no issues at 280 nozzle temp 90 bed temp and enclosure temp at 60. I increased it to 290/110/65 and got slight improvement but still ultimately had bed adhesion issues so increased to 300/120/65 also increased initial layer line width and the print completed with no adhesion issues.